You will design the analog hardware for a data-acquisition system to measure displacement (i.e., vibrations, distance). The range of displacement is –1 to +1 mm. Each resistance in the bridge (R1, R2, R3, and R4) is linear to displacement having a sensitivity of 10 Ω/mm. At zero displacement, all four resistors are 1000 Ω. The displacement signal exists in the 0 to 1000 Hz frequency band. With displacement equal to –1 mm, R1 1010, R2 990, R3 990, and R4 1010 Ω. With displacement equal to +1 mm, R1 990, R2 1010, R3 1010, and R4 990 Ω.
a) Create a design table with displacement R1, R2, R3, R4, bridge output (V2-V1), and ADC input.
b) A good CMRR is required. Design the analog circuit using just the single +5V supply mapping the bridge output (V2-V1) into the ADC input channel 3 (V3). You do not need to add an antialiasing analog low-pass filter. Show chip numbers, resistor values, but not pin numbers.
Delivering a high-quality product at a reasonable price is not enough anymore.
That’s why we have developed 5 beneficial guarantees that will make your experience with our service enjoyable, easy, and safe.
You have to be 100% sure of the quality of your product to give a money-back guarantee. This describes us perfectly. Make sure that this guarantee is totally transparent.
Read moreEach paper is composed from scratch, according to your instructions. It is then checked by our plagiarism-detection software. There is no gap where plagiarism could squeeze in.
Read moreThanks to our free revisions, there is no way for you to be unsatisfied. We will work on your paper until you are completely happy with the result.
Read moreYour email is safe, as we store it according to international data protection rules. Your bank details are secure, as we use only reliable payment systems.
Read moreBy sending us your money, you buy the service we provide. Check out our terms and conditions if you prefer business talks to be laid out in official language.
Read more